MPE/iX Error Messages Manual Vol 1 (32650-90878)

96 Chapter2

Command Interpreter

(CIERR)

ACTION Check the syntax and reenter the command.

1014 MESSAGE UNABLE TO OPEN LIST FILE. FORCED TO $STDLIST.

(CIWARN 1014)

CAUSE Same as message content.

ACTION None. Information only.

1015 MESSAGE INSUFFICIENT STACK TO DO STORE. (CIERR 1015)

CAUSE Same reason as the message indicates.

ACTION Alter the STORE ﬁle set and make it smaller. If you are

doing a native mode STORE (without specifying

TRANSPORT), you might try increasing the size of the

stack by issuing the :RUN STORE command, and

specifying the NM STACK= option with a larger size

stack. Refer to a utilities reference manual for further

information.

1016 MESSAGE FOPTIONS ON TAPE WRONG - SHOULD BE NOCCTL,

UNDEFINED RECORD FORMAT, BINARY, NEW. (CIERR

1016)

CAUSE The ﬁle format speciﬁed does not match the tape format.

ACTION Issue a :FILE command to deﬁne a ﬁle equation specifying

the correct format. Reissue the operation and

backreference that ﬁle equation.

1017 MESSAGE AOPTIONS ON TAPE WRONG - SHOULD BE WAIT,

EXCLUSIVE, NO MULTIRECORD, WRITE ONLY. (CIERR

1017)

1018 MESSAGE CAN ONLY STORE TO TAPE OR SERIAL DISC. (CIERR

1018)

CAUSE A device other than a tape or disk was speciﬁed with the

STORE command.

ACTION Reenter the command making sure the device speciﬁed is

a tape or disk.

1019 MESSAGE IRRECOVERABLE ERROR ON SCRATCH FILE - STORE

STOPPED. (CIERR 1019)

CAUSE Same as the message.

ACTION Reenter the command using a different ﬁle for a scratch

ﬁle.

1020 MESSAGE DISK ERROR ON LABEL OF FILE ! - STORE

STOPPED. (CIERR 1020)

CAUSE An error occurred while reading the label of the ﬁle.

ACTION Contact your Hewlett-Packard representative.

1021 MESSAGE BREAK WHILE DOING STORE. (CIWARN 1021)