MPE/iX Error Messages Manual Vol 1 (32650-90878)

94 Chapter2
Command Interpreter
(CIERR)
response to the "ABORT? (YES/NO)" message.
ACTION Enter YES or NO in response to the "ABORT? (YES/NO)"
message.
991 MESSAGE NO PARAMETERS ARE ALLOWED WITH "ABORT".
(CIERR 991)
CAUSE An attempt was made to enter parameters with the
ABORT command.
ACTION Do not enter parameters with the ABORT command.
100 MESSAGE ERROR WHILE WRITING TO TAPE - STORE STOPPED.
(CIERR 1000)
CAUSE An error occurred while writing to a STORE tape.
ACTION Reenter the STORE command using a new tape.
1001 MESSAGE SPECIAL CHARACTER IN TAPE FILE NAME. (CIERR
1001)
CAUSE A special character was found in the specified tape file
name.
ACTION Reenter the tape file name making sure that valid file
naming conventions are used.
1002 MESSAGE EXPECTED ALPHABETIC CHARACTER TO START TAPE
NAME. (CIERR 1002)
CAUSE The first character of the start tape name was not
alphabetic.
ACTION Reenter the tape file name making sure that valid file
naming conventions are used.
1003 MESSAGE TAPE FILE NAME > 8 CHARACTERS LONG. (CIERR
1003)
CAUSE The tape file name entered exceeded the maximum length
of 8 characters.
ACTION Reenter the tape file name making sure that valid file
naming conventions are used.
1004 MESSAGE EXPECTED "*" INDICATING BACK REFERENCE FOR
TAPE FILE. (CIERR 1004)
CAUSE The name of the magnetic tape file containing the files to
be restored was not backreferenced with an asterisk (*).
ACTION Use a FILE equation before invoking the RESTORE
command.
1005 MESSAGE TAPE FILE NAME IS A REQUIRED PARAMETER.
(CIERR 1005)
CAUSE The tape file name was omitted with the command entry.