MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 59
Command Interpreter
(CIERR)
ACTION Re-enter the command and supply a VSD name.
572 MESSAGE VSD NAME > 8 CHARACTERS LONG. (CIERR 572)
CAUSE The name specified for the Volume Set Definition (VSD) is
more than 8 characters long.
ACTION Re-enter the command and supply a VSD name that is up
to 8 characters long.
573 MESSAGE EXPECTED VSD NAME; "@" NOT PERMITTED. (CIERR
573)
CAUSE "@" was specified instead of an alphanumeric Volume Set
Defintion (VSD) name.
ACTION Re-enter the command and supply a completely
alphanumeric VSD name.
574 MESSAGE EMBEDDED NON-ALPHANUMERIC CHARACTER IN VSD
NAME. (CIERR 574)
CAUSE A control or unprintable character was typed as part of the
Volume Set Definition (VSD) name.
ACTION Re-enter the command. Make sure that you do not type in
any control characters.
575 MESSAGE MISSING DELIMITER AFTER VSD NAME. (CIERR 575)
CAUSE The command interpreter expected a delimiter after the
Volume Set Definition (VSD) name but did not find it.
ACTION Re-enter the command and supply a delimiter after the
VSD name.
576 MESSAGE GENERIC VSD NAME IS NOT PERMITTED IN THIS
COMMAND. (CIERR 576)
CAUSE A wild card character, was used in place of the Volume Set
Definition (VSD) name.
ACTION Re-enter the command and supply a completely
alphanumeric VSD name.
579 MESSAGE VSD MAY NOT HAVE A LOCKWORD. (CIERR 579)
CAUSE A lockword was specified for the Volume Set Definition
(VSD).
ACTION Re-enter the command without specifying a lockword on
the VSD.
580 MESSAGE UNKNOWN SYSTEM DEFINED FILE NAME. (CIERR 580)
CAUSE Only $STDIN, $STDINX, $STDLIST, $NULL,
$NEWPASS, AND $OLDPASS are accepted as valid
system defined files.
ACTION Re-enter the command and supply the appropriate system