MPE/iX Error Messages Manual Vol 1 (32650-90878)

452 Chapter6
File System (Native Mode)
(Subsystem 143)
CAUSE A CM error was detected.
ACTION File an SR.
615 MESSAGE EXCEEDED THE MAXIMUM MESSAGE FILE OPENS FOR
WRITE ACCESS (FSERR 15)
CAUSE A CM error was detected.
ACTION File an SR.
616 MESSAGE More than 255 opens of a file occurred.
(FSERR 616)
617 MESSAGE A magnetic tape runaway occurred. (FSERR 617)
618 MESSAGE The device powered up. (FSERR 618)
619 MESSAGE The forms control was reset. (FSERR 619)
620 MESSAGE This is an invalid operation. (FSERR 620)
621 MESSAGE A data parity error occurred. (FSERR 621)
622 MESSAGE A software time out occurred. (FSERR 622)
623 MESSAGE The procedure detected the end of the tape.
(FSERR 623)
624 MESSAGE The unit is not ready. (FSERR 624)
625 MESSAGE There is no WRITE ring on the tape. (FSERR
625)
626 MESSAGE A transmission error occurred. (FSERR 626)
627 MESSAGE An I/O time out occurred. (FSERR 627)
628 MESSAGE A timing error on data overrun occurred.
(FSERR 628)
629 MESSAGE An SIO failure occurred. (FSERR 629)
630 MESSAGE A unit failure occurred. (FSERR 630)
631 MESSAGE The procedure detected the end of the line.
(FSERR 631)
632 MESSAGE A software abort occurred. (FSERR 632)
633 MESSAGE Data was lost. (FSERR 633)
634 MESSAGE The unit is not on line. (FSERR 634)
635 MESSAGE The data-set is not ready. (FSERR 635)
636 MESSAGE This is an invalid disk address. (FSERR 636)
637 MESSAGE This is an invalid memory address. (FSERR
637)
638 MESSAGE A tape parity error occurred. (FSERR 638)
639 MESSAGE Recovered tape error occurred. (FSERR 639)