MPE/iX Error Messages Manual Vol 1 (32650-90878)

386 Chapter5
Error Messages V i C 5
(Subsystem 196)
18 MESSAGE Failure on FGETINFO (outputfile).
CAUSE CCL returned from the
FGETINFO intrinsic called from
MERGE/XL.
ACTION Make sure the output file number has not been corrupted.
Also refer to the MPE/iX Intrinsics Reference Manual.
19 MESSAGE $NULL is not a valid input file.
CAUSE You specified $NULL as an input file.
ACTION Change the file specification to another file.
21 MESSAGE Sort language is not supported.
CAUSE The language specified in the second element of the
charseq parameter array in HPMERGEINIT is not
supported on your system.
ACTION Check valid language IDs by running NLUTIL. Set the
second element of the
charseq parameter array to a valid
language ID.
22 MESSAGE NLINFO error obtaining the
length of the collating sequence
table.
CAUSE Native Language (NL) not installed or internal NL error.
ACTION Contact your system manager or your Hewlett-Packard
representative.
23 MESSAGE NLINFO error loading the collating sequence.
CAUSE Native Language (NL) not installed or internal NL error.
ACTION Contact your system manager or your Hewlett-Packard
representative.
24 MESSAGE Invalid charseq parameter.
CAUSE The first element of the
charseq parameter array is a
value other than one.
ACTION Set the first element in the
charseq array to one.
25 MESSAGE The two-byte collating sequence table is not
specified.
CAUSE Two-byte collating sequence table was not specified in the
charseq parameter although a two-byte key was specified
in the
keys parameter.
ACTION Specify a two-byte sequence in both the
charseq and
keys parameters.
26 MESSAGE Failure on FGETINFO (two-byte collating
sequence table).
CAUSE CCL returned from the FGETINFO intrinsic called from