MPE/iX Error Messages Manual Vol 1 (32650-90878)

346 Chapter4
Error Messages V i C 4
Error, Warning, and Status Messages
CAUSE An error occurred while reading an FCOPY command
from $STDIN.
ACTION In a job: re-submit the job. In a session: re-enter the
command.
MESSAGE WRITE ERROR TO COMMAND LISTFILE
CAUSE An error occurred while writing an FCOPY message to
$STDLIST.
ACTION It is likely that nothing serious occurred and all FCOPY
operations were performed successfully. To make sure,
however, do the following: In a job: re-submit the job. In a
session: re-enter the most recent FCOPY command.
MESSAGE SYNTAX ERROR: EOF FOUND IN COMMAND FILE,
MISSING
EXIT COMMAND
CAUSE The command input file did not contain an EXIT
command.
ACTION Correct the input file.
3 MESSAGE SYNTAX ERROR: IN SUBSET OPTION
CAUSE The SUBSET function was not specified properly.
ACTION In a job: correct the command and re-submit the job. In a
session: re-enter the command using the correct format.
4 MESSAGE SYNTAX ERROR: IN TITLE OPTION
CAUSE The TITLE option of the DISPLAY function was not
specified properly.
ACTION In a job: correct the command and re-submit the job. In a
session: re-enter the command using the correct format.
5 MESSAGE SYNTAX ERROR: IN IGNERR OPTION
CAUSE The "ignore errors" function is not specified properly.
ACTION In a job: correct the command and re-submit the job. In a
session: re-enter the command using the correct format.
6 MESSAGE SYNTAX ERROR: IN VERIFY OPTION
CAUSE The "verify" function was not specified properly.
ACTION In a job: correct the command and re-submit the job. In a
session: re-enter the command using the correct format.
7 MESSAGE SYNTAX ERROR: IN SKIPEOF OPTION
CAUSE The "skip end-of-file" function was not specified properly.
ACTION In a job: correct the command and re-submit the job. In a
session: re-enter the command using the correct format.