MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 315
Command Interpreter
(CIERR) 1901-12256
ACTION Issue the SETCLOCK;CANCEL command, followed by a
SETCLOCK command implementing the desired change.
12227 MESSAGE WG parameter requires SM or OP capability.
(CIERR 12227)
CAUSE You need SM or OP capability to use this parameter.
ACTION Contact your System Manager.
12250 MESSAGE Specified job queue does not exist. (CIERR
12250)
CAUSE The job queue you specified does not exist.
ACTION Check if the job queue exists or its name was entered
correctly. Check the output of :LISTJOBQ for correct
spelling of the job queue name.
12251 MESSAGE Cannot purge job queue as there are jobs running/waiting
in that queue(CIERR 12251)
CAUSE You have specified a job queue that has jobs executing or
waiting in it.
ACTION Check if any job is executing or waiting in that Job.
12252 MESSAGE Cannot purge system default job queue. (CIERR 12252)
CAUSE You have attempted to purge the system default jobqueue
(HPSYSJQ). This is not allowed.
ACTION No action required.
12253 MESSAGE Specified job queue already exists. (CIERR 12253)
CAUSE The job queue name you specifed already exists in the
system.
ACTION You may re-enter the command and supply another name.
12254 MESSAGE Number of job queues has reached the maximum limit
(255)(CIERR 12254)
CAUSE An attempt was made to create more than 255 job queues.
255 is the maximum number of job queues that can be
created.
ACTION Check if the number of job queues has reached the
maximum ( by doing :LISTJOBQ). You may delete any
unnecessary job queues so that new job queues can be
created.
12254 MESSAGE Number of job queues has reached the maximum limit
(255)(CIERR 12254)
CAUSE An attempt was made to create more than 255 job queues.
255 is the maximum number of job queues that can be
created.