MPE/iX Error Messages Manual Vol 1 (32650-90878)

314 Chapter3
Command Interpreter
(CIERR) 1901-12256
11712 MESSAGE The TIME parameter has an incorrect format.
Expected hh:mm[:ss]. (CIERR 11712)
CAUSE At least one of the numeric values for hours or minutes
was not provided, or the values were not separated with a
colon.
ACTION Provide the TIME parameter in the form hh:mm, or
optionally hh:mm:ss.
11713 MESSAGE The specified system time is out of range.
(CIERR 11713)
CAUSE The TIME parameter was provided with numeric values
for hour, minute or second which exceeded the range
associated with hours, minutes or seconds.
ACTION Provide the TIME parameter with hours in the range 0
through 23, minutes in the range 0 through 59, and
optionally seconds in the range 0 through 59.
11715 MESSAGE The TIMEZONE parameter has an incorrect
format. (CIERR 11715)
CAUSE The TIMEZONE was provided either with a missing value
for hours or minutes or with a missing colon separating
hours from minutes.
ACTION Provide the TIMEZONE parameter in the form Ehh:mm
or Whh:mm.
11716 MESSAGE The TIMEZONE parameter requires a preceding W
or E. (CIERR 11716)
CAUSE The TIMEZONE parameter was provided without a
preceding W or E indicating whether the hemisphere
should be Western or Eastern.
ACTION Provide the TIMEZONE parameter in the form Ehh:mm
or Whh:mm.
11717 MESSAGE The specified TIMEZONE is out of range.
(CIERR 11717)
CAUSE The TIMEZONE parameter represented a time zone
which is not within the range of accepted time zones.
ACTION Provide the TIMEZONE parameter with time values
ranging from 0:00 to 12:59, preceded by a "W" or "E" to
represent the hemisphere.
11718 MESSAGE A current correction is in effect. Use
SETCLOCK;CANCEL. (CIERR 11718)
CAUSE The SETCLOCK command was issued in an attempt to
change the system time or timezone while a current
correction is still in effect.