MPE/iX Error Messages Manual Vol 1 (32650-90878)

310 Chapter3
Command Interpreter
(CIERR) 1901-12256
(CIWARN 10929)
CAUSE An :SPUCONTROL SETUP, :SWITCHBACK, or
:SWITCHOVER was entered. While switching the volume
set, an error occurred. The volume set will not be switched,
and it cannot be restored to its original state. The
command will continue to switch the remaining volume
sets if possible. The volume sets that were switched before
the error occurred will remain on the system they were
switched to. An :SPUCONTROL SETUP is not complete
until all SPUSO volume sets are mounted on their home
systems.
ACTION Reboot the current system and the alternate system, and
re-enter the command.
10930 MESSAGE UNABLE TO SEND INFORMATION ON VOLUME SET
!volset name TO SYSTEM !sysname. (CIERR
10930)
CAUSE An :SPUCONTROL SETUP was entered, but set
information for the indicated volume set mounted on the
current system could not be sent to the alternate system.
It is important that the information is sent when adding
new volumes that will be in the SPUSO configuration to
the system.
ACTION Check all connections to both system. Perform a :DSTAT
on both systems to see if corresponding volumes in the
volume set exist on both systems.
10931 MESSAGE VOLUME SET !volset name LOCKED BY BOTH
SYSTEMS. (CIERR 10931)
CAUSE A previous :SPUCONTROL SETUP failed. Due to a
communication error, the volume set was left in a "locked"
state on the current and alternate systems. It should be in
a "locked" state on one system, and a "loner" state on the
other. This, and subsequent executions of :SPUCONTROL
SETUP will fail because of the volume set state.
ACTION Perform a :DSTAT on both systems to check the state of
the volume set. Reboot both systems and re-enter the
command.
11050 MESSAGE This parameter requires SM capability. (CIERR
11050)
CAUSE You need to have System Manager capability to specify
this parameter.
ACTION Contact your System Manager.
11055 MESSAGE ";HP" and JOB= cannot be used together.
(CIERR 11055)