MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 29
Command Interpreter
(CIERR)
CAUSE You have entered something in the device name that the
system does not recognize.
ACTION Check your command line for spelling errors. Review the
command syntax, including what device names are
allowed, by invoking the online Help Facility or referring
to the MPE/iX Commands Reference Manual; then
reenter the command, specifying an appropriate device
name.
259 MESSAGE DS CLASS NAME > 8 CHARACTERS LONG. (CIERR
259)
CAUSE You have entered a DS class name that is longer than the
allowable eight characters.
ACTION Reenter the command, limiting the DS class name to eight
or fewer characters.
260 MESSAGE DEVICE NAME TOO LONG. 63 CHARACTERS IS THE
MAXIMUM. (CIERR 260)
CAUSE You have entered a device name that is longer than the
allowable 63 characters.
ACTION Reenter the command, limiting the device name to 63 or
fewer characters.
261 MESSAGE OUTPUT PRIORITY AND/OR NUMBER OF COPIES MAY
BE SPECIFIED ONLY FOR OUTPUT DEVICEFILES.
(CIERR 261)
CAUSE You have attempted to specify an output priority and/or a
number of copies for something other than an output
device file; this is not allowed.
ACTION To review the command syntax, invoke the online Help
Facility or refer to the MPE/iX Commands Reference
Manual; then reenter the command with the appropriate
parameters specified.
262 MESSAGE OUTPUT PRIORITY MUST BE AN INTEGER BETWEEN 1
AND 13. (CIERR 262)
CAUSE You have entered something that the system cannot accept
as an output priority.
ACTION You must specify a positive number between 1 and 13 to
indicate the output priority. To review the command
syntax, invoke the online Help Facility or refer to the
MPE/iX Commands Reference Manual; then reenter the
command with the appropriate output priority specified.
263 MESSAGE NUMBER OF COPIES MUST BE AN INTEGER BETWEEN 1
AND 127. (CIERR 263)
CAUSE You have entered something that the system cannot accept