MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 261
Command Interpreter
(CIERR) 1901-12256
patterns.
8168 MESSAGE ! IS NOT PROGRAMMATICALLY AVAILABLE. (CIWARN
8168)
CAUSE An attempt was made to access a function variable that
accesses the command control block (CCB).
ACTION Do not attempt to access these variables
programmatically. They are only meaningful from the
command interpreter (CI). Refer to the MPE/iX
Commands Reference Manual, for a list of variables.
8169 MESSAGE ! IS NOT PROGRAMMATICALLY AVAILABLE. (CIERR
8169)
CAUSE An attempt was made to access a function variable that
accesses the command control block (CCB).
ACTION Do not attempt to access these variables
programmatically. They are only meaningful from the
command interpreter (CI). Refer to the MPE/iX
Commands Reference Manual, for a list of variables.
8170 MESSAGE VARIABLE IS NOT DELETABLE. (CIWARN 8170)
CAUSE An attempt was made to delete an HP predefined variable.
ACTION Do not attempt to delete these variables.
8171 MESSAGE SYSTEM OUT OF RESOURCES. VAR TBL NOT BUILT.
(CIERR 8171)
CAUSE Unknown.
ACTION Reenter the command. If it fails consistently, contact your
system manager or support representative.
8172 MESSAGE VARIABLE IN USE, CANNOT BE ALTERED AT THIS
TIME. (CIERR 8172)
CAUSE The variable is being accessed by some other process.
ACTION Reexecute the command.
8173 MESSAGE CLOSING SQUARE BRACKET MISSING, INVALID
VARIABLE SET. (CIERR 8173)
CAUSE An opening square bracket was not paired with a closing
square bracket.
ACTION Add a closing square bracket to the bracketed part of the
command line.
8174 MESSAGE UNABLE TO SET HPTYPEAHEAD. (CIWARN 8174)
CAUSE An attempt was made to setvar HPTYPEAHEAD from a
job or from redirected input.
ACTION Do not attempt to use typeahead from within a job or from