MPE/iX Error Messages Manual Vol 1 (32650-90878)

202 Chapter3
Command Interpreter
(CIERR) 1901-12256
CAUSE The device specified as system monitor is not enabled.
ACTION Enable the system monitor.
3434 MESSAGE SYSTEM MONITOR IS RUNNING, USE OPERATOR
COMMAND -MOFF-. (CIERR 3434)
CAUSE The system monitor is currently running.
ACTION To turn off the monitor, use the alternate operator
command, MOFF.
3435 MESSAGE LDEV MUST BE A 7970E OR 7970B TAPE DRIVE.
(CIERR 3435)
CAUSE Device specified is neither a 7970E nor a 7970B tape drive.
ACTION Specify either a 7070E or 7970 tape drive.
3460 MESSAGE EXPECTED AT LEAST ONE PARAMETER, THE MINIMUM
CLOCK CYCLE. (CIERR 3460)
CAUSE The minimum clock cycle parameter was expected.
ACTION Check syntax.
3461 MESSAGE TUNE HAS AT MOST 16 PARAMETERS. (CIERR 3461)
CAUSE You used too many parameters for the TUNE command.
ACTION Check command syntax.
3463 MESSAGE MINIMUM CLOCKCYCLE MUST BE A NUMBER. (CIERR
3463)
CAUSE The parameter used to set the minimum clockcycle was
not a number.
ACTION Use a number to set the minimum clockcycle.
3464 MESSAGE THE QUEUE DESCRIPTOR CONSISTS OF AT MOST 4
PARAMETERS, BASE, LIMIT, MINQUANTUM,
MAXQUANTUM. (CIERR 3464)
CAUSE Only four parameters are used for the queue descriptor.
ACTION Use any of the four parmeters.
3465 MESSAGE THE QUEUE PARAMETER RELATIONSHIP INVALID,
BASE<=LIMIT AND MINQUANTUM<=MAXQUANTUM.
(CIERR 3465)
CAUSE Parameter is not valid.
ACTION Check command syntax. The BASE must be less than the
limit and MIN must be less than the maximum. Make
sure your values meet this criteria.
3466 MESSAGE AT LEAST ONE QUEUE DESCRIPTOR PARAMETER MUST
BE PROVIDED. (CIERR 3466)
CAUSE No parameters given.