MPE/iX Error Messages Manual Vol 1 (32650-90878)

200 Chapter3
Command Interpreter
(CIERR) 1901-12256
3409 MESSAGE UNABLE TO LOAD MIO'INIT. (CIERR 3409)
CAUSE MIO'INIT process is not able to be accessed.
ACTION Check MIO'INIT process.
3410 MESSAGE MEASIO ERROR. (CIERR 3410)
CAUSE Process has encountered an error.
ACTION Check measurement interface code segmenter.
3411 MESSAGE UNABLE TO LOAD MIO'RESET. (CIERR 3411)
CAUSE Program requested cannot be accessed or found.
ACTION Check program.
3412 MESSAGE TAPE CONTROLLER SERVICING OTHER TAPE UNITS.
(CIERR 3412)
CAUSE Device requested can not currently be accessed.
ACTION Retry in a few minutes.
3413 MESSAGE INTERNAL SYSTEM ERROR,CANNOT ENABLE MEASIO.
(CIERR 3413)
CAUSE A problem with the internal system has been detected.
ACTION Call your service representative.
3414 MESSAGE BAD STATUS RECEIVED FROM MEASIO. (CIERR 3414)
CAUSE Faulty status information has been received from the
measurement interface.
ACTION Call your service representative.
3415 MESSAGE UNABLE TO LOAD "MEASIO" PROGRAM. (CIERR 3415)
CAUSE System unable to locate and load the MEASIO program.
3420 MESSAGE LDEV REQUIRED FOR THIS COMMAND. (CIERR 3420)
CAUSE Logical device name is required for this command.
ACTION Supply a logical device name.
3421 MESSAGE MAXIMUM NUMBER OF PARAMETERS EXCEEDED. (CIERR
3421)
CAUSE The parameter limit for this command has be surpassed.
ACTION Check command syntax.
3422 MESSAGE LOGICAL DEVICE UNAVAILABLE. (CIERR 3422)
CAUSE The logical device referenced is not available.
ACTION Check device and reenter command.
3423 MESSAGE LABELED TAPE MOUNTED ON SPECIFIED DEVICE.
(CIERR 3423)