MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 197
Command Interpreter
(CIERR) 1901-12256
(CIERR 3370)
CAUSE Two parameters are to be provided; LDEV and
ENABLE/DISABLE.
ACTION Provide both parameters.
3371 MESSAGE THE ONLY VALID DELIMITER BETWEEN PARMS IS A
COMMA. (CIERR 3371)
CAUSE A command line delimiter other than a comma (,) has been
used.
ACTION Use the comma (,) as a delimiter in the command line.
3372 MESSAGE INVALID NUMERICAL VALUE FOR LDEV. (CIERR
3372)
CAUSE The number given as the LDEV value is not acceptable.
ACTION Provide the correct LDEV number.
3373 MESSAGE EXPECT ENABLE OR DISABLE. (CIERR 3373)
CAUSE The command syntax requires either ENABLE or DISABLE
to be specified.
ACTION Specify either ENABLE or DISABLE in the command line
syntax.
3374 MESSAGE INVALID DELIMITER. (CIERR 3374)
CAUSE An unrecognized syntax delimiter in the command line
was used.
ACTION Check command syntax and reenter the command.
3375 MESSAGE IO TIMED OUT BEFORE COMPLETING, PLEASE
RE-ENTER. (CIERR 3375)
CAUSE The input/output device's time limit expired before
completion of a given task.
ACTION Reenter task.
3376 MESSAGE SIO FAILURE, PLEASE RE-ENTER COMMAND (CIERR
3376)
CAUSE Start input/output device failure.
ACTION Reenter command.
3377 MESSAGE UNIT FAILURE. (CIERR 3377)
CAUSE Device failure.
ACTION Check device.
3378 MESSAGE CHANNEL FAILURE, PLEASE RE-ENTER COMMAND
(CIERR 3378)
CAUSE Device controller board, used to calculate the logical