MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 175
Command Interpreter
(CIERR) 1901-12256
3047)
CAUSE The command entered is executable from the console only
unless distributed with the ALLOW command, or if the
JOBSECURITY is set to LOW.
ACTION Issue the command from the console, or have the operator
set JOBSECURITY to LOW.
3048 MESSAGE REPLY HAS AT LEAST TWO PARAMETERS. (CIERR
3048)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3049 MESSAGE REPLY HAS ONLY THREE PARAMETERS. (CIERR 3049)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3050 MESSAGE EXPECTED PROCESS NUMBER BETWEEN 1 AND !.
(CIERR 3050)
CAUSE The process number specified is not within the valid
range.
ACTION Reenter the command making sure the process number
specified is within the valid range.
3051 MESSAGE NO REPLY OUTSTANDING FOR PROCESS. (CIERR
3051)
3052 MESSAGE REPLY EXPECTED YES/NO OR NUMBER. (CIERR 3052)
3053 MESSAGE REPLY EXPECTED YES/NO. (CIERR 3053)
3054 MESSAGE REPLY EXPECTED NUMBER. (CIERR 3054)
3055 MESSAGE ASSOCIATE HAS EXACTLY 1 PARAMETER, THE DEVICE
CLASS. (CIERR 3055)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3056 MESSAGE DISASSOCIATE HAS ONLY 1 PARAMETER, THE DEVICE
CLASS. (CIERR 3056)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3057 MESSAGE YOU ALREADY HAVE ASSOCIATED ONE OR MORE
DEVICES IN THAT DEVICE CLASS. (CIERR 3057)
CAUSE A device class was specified with the ASSOCIATE
command that already has one or more devices associated.
ACTION Refer to the ASSOCIATE command in the MPE/iX
Commands Reference Manual for additional information.