MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 143
Command Interpreter
(CIERR)
ACTION Enter the SETJCW again using the syntax shown in the
error message.
1722 MESSAGE OUT OF SPACE IN JOB DIRECTORY TABLE - UNABLE
TO ADD NEW JCW. (CIERR 1722)
CAUSE The job directory table is full.
ACTION Contact your system manager.
1723 MESSAGE UNLESS A :CONTINUE IS IN EFFECT, THE
REMAINDER OF THE CURRENT UDC WILL BE FLUSHED.
(CIWARN 1723)
CAUSE The next command in the UDC will result in an error.
ACTION Place a CONTINUE command on the line immediately
preceding the command that will result in an error.
1724 MESSAGE UNLESS A :CONTINUE IS IN EFFECT, THE
REMAINDER OF THE JOB WILL BE FLUSHED. (CIWARN
1724)
CAUSE The next command in the job will result in an error.
ACTION Place a CONTINUE command on the line immediately
preceding the command that will result in an error.
1725 MESSAGE JCWNAME CANNOT BE A VALID JCW VALUE (CIERR
1725)
CAUSE Same as the message.
ACTION None; the message is for information only.
1726 MESSAGE CANNOT SETJCW ON A SYSTEM-RESERVED JCW.
(CIERR 1726)
CAUSE Same as the message.
ACTION None; the message is for information only.
1728 MESSAGE VALID VALUES FOR JCW HPTIMEOUT ARE BETWEEN 0
AND 546 (CIERR 1728).
CAUSE The value specified for HPTIMEOUT was less than 0 or
more than 546.
ACTION Specify a valid value for HPTIMEOUT between 0 and 546.
1730 MESSAGE EXPECTED JUST ONE JCW NAME. IGNORED. (CIWARN
1730)
CAUSE You entered a syntax error.
ACTION None; the message is for information only.
1731 MESSAGE THIS JCW HAS NOT BEEN DEFINED. (CIERR 1731)
CAUSE You referenced an undefined JCW.
ACTION Make sure that you entered the name of a defined JCW. If