MPE/iX Error Messages Manual Vol 1 (32650-90878)

140 Chapter2
Command Interpreter
(CIERR)
is rinnumber.
ACTION Specify only the rinnumber with the FREERIN command.
1692 MESSAGE CAN'T ALLOCATE RIN, RIN TABLE FULL. (CIERR
1692)
CAUSE Once the RIN table becomes full no additional RINs can be
allocated.
ACTION Waituntil a RIN becomes available or request your system
manager to raise the maximum number of RINs that can
be assigned.
1693 MESSAGE THIS RIN ISN'T ALLOCATED. (CIERR 1693)
CAUSE Either the RIN number does not exist or it exists but is not
owned by the current user.
ACTION Check the RIN number and make sure it is allocated to the
current user.
1694 MESSAGE RIN IN USE, COMMAND IGNORED. (CIERR 1694)
CAUSE The specified RIN is currently being accessed.
ACTION Try again to see if RIN is free for your use.
1695 MESSAGE EXPECTED ASSIGNED RIN NUMBER BETWEEN 1 AND
32767, FOUND "!". (CIERR 1695)
CAUSE Same as the message.
ACTION Check the syntax and reenter the command.
1696 MESSAGE RIN PASSWORD IS TOO LONG. (CIERR 1696)
CAUSE A RIN password can contain no more that eight
alphanumeric characters beginning with an alphabetic
character.
ACTION Specify a password that contains eight or fewer
alphanumeric characters beginning with an alphabetic
character.
1697 MESSAGE RIN PASSWORD CAN CONTAIN ONLY ALPHANUMERIC
CHARACTERS. (CIERR 1697)
CAUSE Only alphanumeric characters are allowed for the RIN
password.
ACTION Specify a RIN password that contains only alphanumeric
characters, beginning with an alphabetic charaater.
1698 MESSAGE RIN PASSWORD MUST START WITH ALPHA CHARACTER.
(CIERR 1698)
CAUSE The RIN password did not begin with an alphabetic
character.
ACTION Specify a RIN password that begins with an alphabetic