MPE/iX Error Messages Manual Vol 1 (32650-90878)

136 Chapter2
Command Interpreter
(CIERR)
ACTION Specify only the input speed and output speed with this
command.
1641 MESSAGE SPEED REQUIRES EITHER AN INPUT OR AN OUTPUT
SPEED. (CIERR 1641)
CAUSE The SPEED command requires either an INPUT or an
OUTPUT speed to be specified.
ACTION Specify either an INPUT or an OUTPUT speed with the
SPEED command.
1642 MESSAGE INPUT SPEED SPECIFIED NOT SUPPORTED BY THIS
DEVICE. (CIERR 1642)
CAUSE The terminal you are using does not support the INPUT
speed you specified.
ACTION Specify a valid INPUT speed.
1643 MESSAGE OUTPUT SPEED SPECIFIED NOT SUPPORTED BY THIS
DEVICE. (CIERR 1643)
CAUSE The terminal you are using does not support the OUTPUT
speed you specified.
ACTION Specify a valid OUTPUT speed.
1644 MESSAGE SPEED CHANGE NOT VERIFIED - OLD SPEED
RETAINED. (CIWARN 1644)
CAUSE The SPEED change you specified was not verified by the
system and the existing SPEED specification will be used.
ACTION Verify the SPEED change by entering MPE
Return at the
terminal. If the characters MPE cannot be verified, the
system assumes that the terminal is to continue at the old
speed.
1645 MESSAGE INPUT SPEED MUST EQUAL OUTPUT SPEED FOR THIS
SYSTEM. WILL ATTEMPT TO CHANGE BOTH SPEEDS TO
VALUE SPECIFIED. (CIWARN 1645)
CAUSE The value specified for INPUT and OUTPUT were not the
same, which is required on this system. The system
attempts to set SPEED to equal values.
ACTION Specify the same value for both INPUT and OUTPUT.
1646 MESSAGE INPUT AND OUTPUT SPEEDS MUST BE EQUAL ON THIS
SYSTEM. (CIERR 1645)
CAUSE The value specified for INPUT and OUTPUT were not the
same, which is required on this system.
ACTION Specify the same value for both INPUT and OUTPUT.
1649 MESSAGE EXPECTED ONE PARAMETER EITHER "ON" OR "OFF".
COMMAND IGNORED (CIERR 1649)