MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 121
Command Interpreter
(CIERR)
ACTION If you want to specify values other than the default
reenter the command.
1457 MESSAGE TERM VALID FOR SESSIONS AND INTERACTIVE JOBS
ONLY, DEFAULT USED. (CIWARN 1457)
CAUSE TERM may only be specified for sessions and interactive
jobs.
ACTION Check with your system supervisor to determine what
default value was specified for TERM during system
configuration.
1458 MESSAGE INVALID TERMINAL TYPE, IGNORED. (CIWARN 1458)
CAUSE The terminal type specified was incorrect and ignored by
the system.
ACTION Check with your system manager to determine what
terminal types are valid to specify.
1459 MESSAGE EXPECTED ONE OF BS, CS, DS, OR ES. DEFAULT
USED. (CIWARN 1459)
CAUSE You did not specify an execution priority queue with the
PRI= keyword. The default value (DS) was used.
ACTION If you want an execution priority queue other than DS
reenter the command and specify another value.
1460 MESSAGE MUST HAVE 'SM' OR 'OP' CAP. TO SPECIFY HIPRI,
MAXIMUM INPRI OF 13 IS USED. (CIWARN 1460)
CAUSE You do not have system manager (SM) or system
supervisor (OP) capability. The jobfence was set to 12 or
less or the job limit was exceeded and you were denied
access to the system.
ACTION Ask your system supervisor to lower the jobfence.
1461 MESSAGE HIPRI PREVIOUSLY SPECIFIED, INPRI VALUE USED.
(CIWARN 1461)
CAUSE Same as message.
ACTION None; the message is for information only.
1462 MESSAGE LOWEST INPRI VALUE IS 1, 1 USED. (CIWARN
1462)
CAUSE Value specified for INPRI was less than 1.
ACTION If you want an INPRI value greater than 1 specify the new
value.
1463 MESSAGE HIGHEST INPRI VALUE IS 13, 13 USED. (CIWARN
1463)
CAUSE The value specified for INPRI exceeded 13.