MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 111
Command Interpreter
(CIERR)
ACTION Check the syntax and reenter the command.
1259 MESSAGE THIS VERSION OF THE UTILITY IS INCOMPATIBLE
WITH THE CURRENT MPE VERSION ON THIS SYSTEM.
(CIERR 1259)
CAUSE Same as message content.
ACTION Notify your system manager.
1300 MESSAGE REMOTE JOBS ARE NOT ALLOWED !. (CIERR 1300)
CAUSE Same as the message.
ACTION None; the message is for information only.
1301 MESSAGE DSLINE CANNOT CONTAIN BOTH OPEN AND CLOSE.
(CIERR 1301)
CAUSE You made a syntax error.
ACTION Check the syntax and reenter the command.
1302 MESSAGE DSLINE REQUIRES AT LEAST ONE PARAMETER.
(CIERR 1302)
CAUSE Syntax error.
ACTION Check the syntax and reenter the DSLINE command.
1303 MESSAGE DSNUMBER SPECIFICATION MUST BE A NUMBER FROM
1 THRU 255. (CIERR 1303)
CAUSE The DSNUMBER specification was less than 1 or greater
than 255.
ACTION Reenter the command making sure the DSNUMBER
specification is between 1 and 255.
1304 MESSAGE DSLINE #L! DOES NOT IDENTIFY AN OPEN DS LINE.
(CIERR 1304)
CAUSE The DSLINE number specified is not an open DS line.
ACTION Reenter the command specifying a valid open DS line.
1305 MESSAGE EXPECTED LINEBUF, PHNUM, LOCID, REMID, OPEN,
CLOSE, QUIET, COMP, NOCOMP OR EXCLUSIVE.
(CIERR 1305)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1306 MESSAGE MULTIPLE USE OF ! IS NOT ALLOWED. (CIERR
1306)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1307 MESSAGE THE SYNTAX FOR ! REQUIRES AN = SIGN FOLLOWED