MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 101
Command Interpreter
(CIERR)
1057 MESSAGE EXPECTED EITHER "," OR ";" TO DELIMIT FILE
SET NAMES. (CIERR 1057)
CAUSE A comma (,) or semicolon (;) was not used to delimit the file
set names.
ACTION Reenter the command making sure a comma or semicolon
is used to delimit file set names.
1058 MESSAGE REDUNDANT SPECIFICATION OF "DATE" PARAMETER.
(CIWARN 1058)
CAUSE The DATE parameter was specified more than once.
ACTION None; the message is for information only. The last
occurrance of the DATE parameter was used.
1059 MESSAGE EXPECTED ONE OF "DATE>=" OR "DATE<=". (CIERR
1059)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1060 MESSAGE STORE RECORD SIZE MUST BE A MULTIPLE OF 256
WORDS AND BE BETWEEN 256 AND !, INCLUSIVE,
FOR THIS DEVICE. (CIERR 1060)
CAUSE The record size specified is invalid.
ACTION Reenter the command making sure the record size
specified is valid.
1061 MESSAGE RESTORE TAPE RECORD SIZE SPECIFIED IS TOO
SMALL. TAPE WAS WRITTEN WITH RECORDS OF SIZE
! WORDS. (CIERR 1061)
CAUSE Same as message content.
ACTION Reenter command making sure the reecord size specified
is correct.
1062 MESSAGE EXPECTED ONE OF "SHOW", "FILES=", "KEEP",
"DEV=", OR "OLDDATE". (CIERR 1062)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1063 MESSAGE UNABLE TO LOCATE FILE EQUATION FOR TAPE FILE.
(CIERR 1063)
CAUSE A file name was backreferenced with an asterisk (*), but
the FILE equation has not been used.
ACTION Use the FILE command to create a file equation before
attempting tto perform a restore operation.
1064 MESSAGE THE STORE/RESTORE TAPE FILE CANNOT BE A
LABELED TAPE ON A REMOTE TAPE DRIVE. (CIERR