MPE Native Fibre Channel Installation onto FC Ldev 1

prompt
run Mapper2.
Mapper2
0/6/0/0 HP 6795A 2G/1G Fibre Chan. Adapter 103CH 1029H 103CH 128CH 0AH
0/6/0/0.8.0.90.0.0.0
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.1
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.2
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.3
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.4
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.5
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.6
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.0.7
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.1.0
HP A6188A Disk Array - - - - HP15
0/6/0/0.8.0.90.0.1.1
HP A6188A Disk Array - - - - HP15
We will assume that the first lun in the array will be the system volume
set
Ldev 1.
2. The address component of the card is 0/6/0/0.8. The 90, you will
notice, is
the value of the port ID from the array and the last three components
are
the SCSI lun and target fields that make up the lun address.
3. Set the Primary bootpath to 0/6/0/0.8.0.90.0.0.0 and restart the
machine.
Installing MPE
4. Install MPE on the primary bootpath as you would normally do and then
reboot.
Configure MPE using SYSGEN and FCSCAN
5. FCSCAN is used to scan the fibre channel adapter for devices. It will
also
return SYSGEN and Boot Menu Paths for any devices it encounters.
:fcscan -h
FCSCAN Version 1.1
Scanning for Fibre Channel devices.
This could take up to a few minutes. Please wait ...
FCSCAN has found the following Fibre Channel I/O Adapter Cards and
Devices
on this system.