HP SNMP/XL User's Guide (36922-90036)

Chapter 3 43
Using SNMPUTIL
SNMP Command Files
Example
The following example walks through the system group of the MIB.
MPEXL: snmpwalk mpenode public system
Name: system.sysDescr.0
Octet String: HP3000 SERIES 925, MPE XL version B.31.00 NS Transport version B.
04.00
Name: system.sysObjectID.0
Object Identifier:
.iso.org.dod.internet.private.enterprises.hp.nm.system.mpe_xl.2
Name: system.sysUpTime.0
Timeticks: (319338799) 3 days, 16:43:07
Name: system.sysContact.0
Display String: John Smith
Name: system.sysName.0
Display String: mpenode.domain.organization
Name: system.sysLocation.0
Display String: in Cupertino, Building 43U Pillar N4
Name: system.sysServices.0
Integer: 72
MPEXL:
SNMPTRAP
The SNMPTRAP command is used to send a SNMP Trap to a remote node
which in most cases is a management node.
SNMPTRAP NODE
COMMUNITY
ENTERPRISE
AGENT_ADDR
GENERIC_TRAP
SPECIFIC_TRAP
TIME_STAMP
[VARIABLE
TYPE
VALUE..]
Parameters
NODE This is a required parameter. It specifies the network
element that is to be the target of the SNMP Trap. This
parameter can either be a fully qualified IP address or a
valid host name that is found in the hosts database. If
you specify 0 the trap is broadcast to all registered
managers.
COMMUNITY This is a required parameter. It defines the SNMP
community name that is used in the SNMP Trap