HP RPG/iX Utilities Reference Manual (30318-90006)

B-103
Alternate Collating Sequence Errors
S Option Errors
Record Type Errors
NUMBER MESSAGE FURTHER EXPLANATION
1015 ALTSEQ TABLE MUST END
WITH **
ALTSEQ specifications must be terminated by a record
containing "**" in columns 1-2.
1016 INVALID HEX DIGIT Each hexidecimal character must be in the range of ASCII
characters "O" through "F"
1023 MAX FIELD LENGTH WITH
ALTSEQ IS 256 CHARACTERS
When an alternate collating sequence is being used, the
maximum length of any control or data field is 256 charac-
ters.
NUMBER MESSAGE FURTHER EXPLANATION
1020 MAXIMUM NUMBER OF RECS TO
BE SORTED INVALID
Columns 10-16 must be blank or contain a valid,
non-negative numeric value.
1021 INVALID EXISTENCE OPTION--
COL 8 MUST BE Y, N, OR BLANK
1022 INVALID FIRST RECMUST BE 0, 1,
OR BLANK ORDS#--COL 7
NUMBER MESSAGE FURTHER EXPLANATION
206 INVALID CONTINUATION-COL 7
MUST BE A, 0, OR BLANK
210 INVALID DATA TYPE-COL 8 MUST
BE A, C, P, OR U
212 INVALID SET-OMIT & FIELD DESC
BUT NO INCLUDE
Omit sets must always be followed by at least one
Include prior to entry of Field Description specs.
214 INCLUDE OR OMIT SPECS AFTER
AN INCLUDE ALL
"Include all," if used, must be specified after all
Include/Omit sets for this record section.
216 INCOMPLETE SET-INCLUDE OR
OMIT W/OUT FOLLOWING FIELD
DESC'S
Include/Omit sets must be followed by Field
Description specs.
236 INVALID RELATION-COL 17-18
MUST BE EQ, NE, LT, GT, LE, OR GE
238 INVALID FACTOR 2 TYPE- COL 19
MUST BE C OR F