HP-PB 100Base-T Network Adapter Installation and Service Guide (B5427-90001)

Chapter 1 17
Installation Procedure
2. Shut Down the Operating System and Switch Off the Computer
2. Shut Down the Operating System and
Switch Off the Computer
1. Before installing the HP-PB 100Base-T Network Adapter, ensure that
the operating system is shut down. Refer to your computer system
manuals for proper shutdown procedures to avoid corruption or loss
of data.
2. Ensure that power to the host computer is switched off and
disconnected from the source power supply.
WARNING Unless otherwise noted in your computer system manuals,
failure to properly shut down the system and remove power may
create a personnel hazard, or may result in hardware damage or
data corruption.