HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 13 181
Configuring Logging
To Access the Logging configuration Screens
To Access the Logging configuration
Screens
Use the following steps to reach the logging configuration screens:
Step 1. Run NMMGR. The Open Configuration/Directory File screen is
displayed.
Step 2. Run NMMGR. The Open Configuration/Directory File screen is
displayed.
Step 3. Press the
[NS] function key. The NS Configuration screen is displayed.
Step 4. Press either the
[Guided Config] or the [Unguided Config] function key.
Step 5. Press the
[Modify Logging] function key if you are in guided
configuration or the
[Go To Logging] function key if you are in unguided
configuration. The first of six logging configuration screens is displayed.
NOTE HP recommends that you use the default logging configuration values
unless your HP representative tells you otherwise. Not using the
recommended default values may result in the degradation of system
performance.