HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 11 169

Conﬁguring the Network Directory

To Conﬁgure Path Report Data for a Node

The Network Directory Data screen (#10) in Figure 11-5 is displayed

when you press the

[Add] or the [Modify] function key at the Select Node

Name screen (#9) in Figure 11-4.

Figure 11-5 Network Directory Data

The function of this screen is to conﬁgure path report data for the node

name listed at the top of the screen. One path report is conﬁgured for

each NI on a node. Because the maximum number of NIs per node is

eleven (twelve including loopback), each node can contain as many as

eleven path reports.

NOTE

NS/SNA is no longer offered as a product and has been removed from

the Corporate Price List. The product is obsolete with no plans for

support.

Step 1. Verify that the yes and no indicators in the TCP, Checksum for TCP

required, and PXP ﬁelds are set correctly.

Step 2. In the IP address ﬁeld, type in the IP address of the node listed in the

Node name ﬁeld.

Step 3. In the type ﬁeld, enter the number that indicates the type of the path:

1 = IP

2 = LAN/IEEE 802.3 (LAN, 100VG, 100BT)

3 = X.25 ACCESS