HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 2
Task Checklists
Checklist M. Using AUTOINST to Add-on and Apply PowerPatch
55
Checklist M. Using AUTOINST to Add-on and Apply PowerPatch
Use this task checklist if your source material is on tape and you are using AUTOINST with a CSLT tape to:
• Add-on purchased products and apply PowerPatch patches
Patch/iX is the recommended method for installing patches because Patch/iX will qualify patches for you. This
checklist is provided only for experienced system installers who elect to use AUTOINST to install
PowerPatches.
Print a copy of this checklist for each system that you are applying add-on products to.
Read and perform the steps only in the following sections:
Begin Preparation Tasks. Does not require exclusive access to the system.
Chapter 3, “Planning for Your Task.”
— 3.1 Verifying Required Materials
— 3.2 General Planning Tasks
— 3.4 Checking Tape Media
— 3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Chapter 4, “Preparing Your System.”
— 4.1 Reserving Disk Space for Tape Tasks
Preparation Tasks completed. Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.
Chapter 5, “Modifying Your System.”
— 5.1 Securing and Backing Up the System for Tape Tasks
— 5.7 Creating CSLT using AUTOINST—Select Option 2, “SUBSYS (Add-On) and PowerPatch.”
— 5.11 Securing the System
Record terminated logging processes:
Record temporary filename for the COMMAND.PUB.SYS file:
— 5.13 Applying the CSLT Modification
— 5.14 Restarting the System
—5.15 Rerunning AUTOINST
Chapter 6, “Finishing the Process.”
— 6.1 Configuring Datacomm and UPS
— 6.4 Setting Passwords, Lockwords, and UDCs
— 6.5 Configuring Manually Installed Products
— 6.7 Performing the Final Reboot