HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 2
Task Checklists
Checklist K. Install a New System
51
Checklist K. Install a New System
Use this task checklist if your source material is on tape and you are using a CSLT tape to:
• Install your system software on new hardware
• Install your system software on new hardware and apply PowerPatch patches
NOTE
• Perform a new installation when new hardware has been shipped to you and the operating
system software is not already installed. This is performed only once in the lifetime of a
computer. Your system software is shipped to you on tape media.
• You cannot apply Reactive patches at the same time you are updating the system. You must
apply Reactive patches after you install the system. To apply Reactive patches (after you
install the system), refer to Checklist A, “Manage Patches,” or Checklist B, “Manage
Patches by Staging Area.”
WARNING Performing the activities in this task DESTROYS ALL FILES THAT EXIST on your
system. Do not perform a new installation on an existing system.
Print a copy of this checklist for each new system that you are installing.
Begin Preparation Tasks. Does not require exclusive access to the system.
Read and perform the steps only in the following sections:
Chapter 3, “Planning for Your Task.”
— 3.1 Verifying Required Materials
Chapter 4, “Preparing Your System.”
No sections in this chapter
Preparation Tasks completed. Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.
Chapter 5, “Modifying Your System.”
— 5.2 Applying the SLT
— 5.3 Listing the System Configuration
Record configuration Group name:
— 5.4 Starting the System
— 5.5 Configuring the System
— 5.6 Checking Volumes
— 5.7 Creating the CSLT using AUTOINST—Select option 3 FOS, SUBSYS, PowerPatch if you
have a PowerPatch tape, or if no PowerPatch, select option 4 FOS and SUBSYS.