HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
399
Cause STAGEMAN failed to find an entry for the staging area in the HP
Stage/iX Globals file when it expected to find one. This indicates a
problem with the HP Stage/iX facility, and should be reported to
Hewlett-Packard.
Action Contact you Hewlett-Packard Response Center for assistance.
1125 Message Could not find file “name” for getting LIF information. (STAGEMAN
1125)
Cause STAGEMAN was unable to find the file specified.
Action None
1126 Message LIF entry must be between 1 and range. Can't delete. (STAGEMAN 1126)
Cause Only 64 entries are allowed in the LIF Directory. Therefore STAGEMAN
will not allow you to index outside of this range.
Action None
1127 Message File equation “name” failed in moving file “name” to the staging area.
CIERROR = value (STAGEMAN 1130)
Cause STAGEMAN received a Command Interpreter (CI) error in attempting to
generate a file equation for moving the file a staging area.
Action Contact your Hewlett-Packard Response Center for assistance.
1131 Message COPY command failed in moving file “name” to the staging area.
CIERROR = value (STAGEMAN 1131)
Cause STAGEMAN received a Command Interpreter (CI) error in attempting to
copy the file into a staging area. The most likely reason for the copy to fail
is an out of disk space condition (this is especially true if the file is
restricted to LDEV1).
Action Determine why the COPY command failed, correct the problem, then
re-execute the command (or Patch/iX process).
1132 Message Rename command failed in moving file “name” to the staging area.
(STAGEMAN 1132)
Cause STAGEMAN received a Command Interpreter (CI) error in attempting to
rename the file into a staging area.
Action Determine why the RENAME command failed, correct the problem, then
re-execute the command (or Patch/iX process).
1133 Message Failed to purge file “name” after staging it. CIERROR = value
(STAGEMAN 1133)
Cause STAGEMAN received a Command Interpreter (CI) error in attempting to
purge a file after it was staged.
Action Determine why the PURGE command failed, then purge the file manually.
There is no need to re-execute the command. However, if this failure
occurred during a run of Patch/iX, the Patch/iX process may need to be
restarted.
1134 Message Failed to do ALTFILE on file “name”. CIERROR = value (STAGEMAN
1134)