HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
396
Cause STAGEMAN cannot set one or both of the STAGEMAN status CI
variables (STAGESTAT and STAGERROR).
Action Determine why the CI variable cannot be modified. Contact your
Hewlett-Packard Response Center for assistance if necessary.
1093 Message User must have SM or OP capability to run STAGEMAN. (STAGEMAN
1093)
Cause For security reasons, STAGEMAN requires the user to have SM (System
Manager) or OP (System Operator) capabilities in order to run
STAGEMAN.
Action Select a user that has SM or OP capability.
1094 Message Incomplete staging area “name”. Cannot validate. (STAGEMAN 1094)
Cause STAGEMAN expects a staging area to be marked as “complete” before it
allows it to be valid. “Complete” means that all files have been staged to
the staging area, and it is now a whole unit. This error occurs when the
staging area has not been marked as complete.
Action Mark the staging area as complete with the COMPLETE command (do an
Expert Mode HELP on COMPLETE for more information).
1095 Message Import failed. Deleted incomplete staging area “name”. (STAGEMAN
1095)
Cause An IMPORT operation failed, and to remove the possibility of leaving
behind a corrupt target (TO) staging area, the target staging area was
deleted. This error normally prints after an initial IMPORT error is
printed, and is therefore issued for information purposes only.
Action Reference the IMPORT error that immediately preceded this one to help
determine the cause of the problem.
1096 Message Failed to delete bad staging area “name”. (STAGEMAN 1096)
Cause An IMPORT operation failed, and to remove the possibility of leaving
behind a corrupt target (TO) staging area, STAGEMAN attempted to
delete the target staging area. However, an error occurred during the
delete operation. The status of the target staging area is unknown at this
point.
Action Determine why the delete of the bad target staging area failed. Contact
your Hewlett-Packard Response Center for assistance if necessary.
1097 Message Could not find error message “name” in the catalog. (STAGEMAN 1097)
Cause STAGEMAN attempted to pull a message out of the STAGEMAN catalog
file (STAGE000.PUB.SYS), but could not find a message that
corresponded to the HP Stage/iX error or warning it encountered.
Action Report this problem to your Hewlett-Packard Response Center.
1098 Message An HP Stage/iX related error occurred during the last system
boot. See the HP Stage/iX log file “/SYS/hpstage/current_log”
for more information. (STAGEMAN 1098)