HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
383
1010 Message Transaction aborted per user request. (STAGEMAN 1010)
Cause The user specified “No” to a confirmation of a command. This warning is
printed for information purposes only.
Action None
1011 Message No help available for this command. (STAGEMAN 1011)
Cause This command is not recognized by STAGEMAN’s HELP facility.
Action Check the spelling of the command.
1012 Message Stage/iX is not initialized. Can't do command. (STAGEMAN
1012)
Cause The HP Stage/iX environment has not been initialized with the
INITIALIZE command. In this context, the command given would either
cause an error or would produce unpredictable results, so the command
was not done.
Action Initialize the HP Stage/iX environment with the INITIALIZE command
(do a HELP on INITIALIZE for more information).
1013 Message Initialize SORT/iX failed. SORT status: Subsys: value, Info: value
(STAGEMAN 1013)
Cause STAGEMAN received an error from the HPSORTINIT intrinsic of the
SORT/iX subsystem.
Action Determine why the HPSORTINIT intrinsic failed. Contact your
Hewlett-Packard Response Center for assistance.
1014 Message Input to SORT/iX failed. SORT status: Subsys: value,Info: value
(STAGEMAN 1014)
Cause STAGEMAN received an error from the HPSORTINPUT intrinsic of the
SORT/iX subsystem.
Action Determine why the HPSORTINPUT intrinsic failed. Contact your
Hewlett-Packard Response Center for assistance.
1015 Message Output from SORT/iX failed. SORT status: Subsys: value, Info: value
(STAGEMAN 1015)
Cause STAGEMAN received an error from the HPSORTOUTPUT intrinsic of the
SORT/iX subsystem.
Action Determine why the HPSORTOUTPUT intrinsic failed. Contact your
Hewlett-Packard Response Center for assistance.
1016 Message No staging areas exist. (STAGEMAN 1016)
Cause No staging areas were found in the HP Stage/iX environment.
Action None if this is an expected event. If one or more staging areas should
exist, then a RECOVER command may be necessary (do a HELP on
RECOVER for more information).
1017 Message The staging area does not exist or no match found. (STAGEMAN
1017)