HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
374
Action • If you are installing a PowerPatch tape, RESTORE AUTOINST and
AICAT000 from the PowerPatch tape. If you are not installing
PowerPatch, UPDATE with the SLT provided by HP, and ensure that
the file exists after the UPDATE.
• Do a LISTF,2 of the file and ensure the CODE is MGCAT.
• Run AUTOINST again.
• Contact your Response Center if further assistance is required.
240 Message AUTOINST CATALOG VUF = v.uu.ff. Invalid Catalog AICAT000
in INSTALL.SYS group The Catalog does not match version
expected
by AUTOINST. (INSTERR #240)
Cause The AUTOINST V.U.F. does not match the V.U.F. found in its catalog,
AICAT000.INSTALL.SYS.
Action • If you are installing a PowerPatch tape, RESTORE AUTOINST and
AICAT000 from the PowerPatch tape. If you are not installing
PowerPatch, UPDATE with the SLT provided by HP, and ensure that
the file exists after the UPDATE.
• Do a LISTF,2 of the file and ensure the CODE is MGCAT.
• Run AUTOINST again.
• Contact your Response Center if further assistance is required.
241 Message Not used
242 Message The installer failed to modify the job and session
limits. (INSTERR #242)
Cause The COMMAND intrinsic returned a nonzero command error when
AUTOINST programmatically attempted to set the job and session limits
to 1,1.
Action • Manually execute the LIMIT command to ascertain why the command
is returning an error.
• If LIMIT can be set manually, run AUTOINST again.
• Contact your Response Center if further assistance is required.
243 Message The Installer could not close filename. (INSTERR #243)
Cause The Installer failed while trying to close the file filename.
Action • Make sure the file exists.
• If the file exists, examine it for accessors other than AUTOINST.
• If the file is being accessed, free up the file.
• Take appropriate corrective measures and run AUTOINST again.
• Contact the Response Center if further assistance is required.
Message 244-249 Not used
250 Message The file id !1 is invalid for the temporary file TMPSTR04,
TMPSTR05,
or TMPSTR08. (INSTERR #250)