HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
372
Cause You entered incorrect passwords for an I-file when MPE prompted for the
passwords. This caused the Installer to fail.
Action • Restart the Installer. The failed I-file will be restreamed.
• Contact the Response Center if further assistance is required.
231 Message Embedded passwords are not allowed due to password security.
The Installer cannot continue. (INSTERR #231)
Cause Embedded passwords are not allowed with the Security Monitor/iX
product. The Installer cannot stream the I-files.
Action • Use the Security Monitor/iX configurator to disable this feature.
• Restart the Installer.
Message 232-234 Not used
235 Message PowerPatch tape is older than the current system powerpatch
(INSTERR #235)
Cause The PowerPatch tape being installed includes patches that are older than
those that were included with the last PowerPatch installation.
Action • Print the file HPSWINFO.PUB.SYS and refer to line 4 of the file to
determine the V.U.F. of the last installed PowerPatch tape. Compare
this V.U.F. to the V.U.F. on the tape label of the PowerPatch tape being
installed.
• The V.U.F. from the tape label should indicate this powerpatch tape as
being older than the last installed PowerPatch.
• Patches to be installed must come from a tape with a V.U.F. at least
equal to the last installed tape. Restart the installation process from
the beginning with the appropriate tape.
• Contact your Response Center if further assistance is required.
236 Message The files from the CSLT/STORE tape were not successfully
restored.
To continue with the installation, consult the customer
installation procedures.
(INSTERR #236)
Cause The JCW STOREJCW was nonzero after AUTOINST executed the
following STORE command to restore the STORE files from the
CSLT/STORE tape:
:RUN STORE.PUB;INFO= RESTORE &
CSLT;@.@.@;CREATE;SHOW=OFFLINE
Action • Ensure that a device with class LP is included in your configuration.
• Use an appropriate text editor to inspect the offline listing generated
by the RESTORE. Identify the spoolfile having RESTORE status by
using the command:
:LISTSPF SELEQ=[FILEDES=OFFLINE]
The last spoolfile displayed will contain the output listing from the
RESTORE command. The error messages in this file will show the
problems encountered in restoring files from the CSLT/STORE tape.
Following are the types of errors that may occur: