HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
371
• Print the INITCIVR.INSTALL. There should be a line with a SETVAR
command for the indicated variable. If the line does exist, execute
INITCIVR and run HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not contain the
SETVAR command for the listed CI variable, VSCLOSE both CD-ROM
volumes and follow the setup procedures in the HPINSTAL manual.
Run HPINSTAL from the start.
222 Message Invalid CI variable type, should be string type (INSTERR #222)
Cause The retrieved CI variable was not a string type as expected. This error is
usually issued in conjunction with INSTERR #221.
Action • Use SHOWVAR variable name to check the status of the variable.
• Print the INITCIVR.INSTALL. There should be a line with a SETVAR
command for the indicated variable. If the line does exist, execute
INITCIVR and run HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not contain the
SETVAR command for the listed CI variable, VSCLOSE both CD-ROM
volumes and follow the setup procedures in the HPINSTAL manual.
Run HPINSTAL again from the start.
223 Message Could not get volume information on first CD-ROM volume name
(INSTERR #223)
Cause HPVOLINFO failed while attempting to get information on the first
CD-ROM volume.
Action • Ensure the CI variable MPE_VOL_1 contains the name of the first
CD-ROM volume (in the form of MPE_ v.uu.ff _1 where v.uu.ff is the
system VUF of the release contained on the CD-ROMs) that is
mounted on the system.
• VSCLOSE both CD-ROM volumes and follow the setup procedures in
the HPINSTAL manual. Run HPINSTAL from the start.
• Save all messages on the screen and check the messages in the bottom
of AUTOLOG. Call the Response Center for further assistance.
224 Message Error reading from terminal with READX (INSTERR #224)
Cause A physical I/O error occurred.
Action Logon again, make sure the first CD-ROM volume is mounted and restart
HPINSTAL.
225 Message Failed to reset file equations for filename. (INSTERR #225)
Cause An attempt to reset the file equation for filename using the
HPCICOMMAND intrinsic failed.
Action Document all the messages received prior to the error and report the
problem to the Response Center for assistance.
Message 226-229 Not used
230 Message Incorrect password provided for Current IFILE indicated
in HPINSTFL. (INSTERR #230)