HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
369
• HPINSTAL can be run again after the first CD-ROM volume has been
mounted (ONLINE/MASTER). If there are two CD-ROM drives, both
CD-ROM volumes should be mounted before running HPINSTAL.
211 Message Could not RESET file equation for NL.PUB.SYS (INSTERR #211)
Cause An attempt to reset the file equation for NL.PUB.SYS through the
hpcicommand intrinsic failed.
Action Document all the messages prior to the error. Save the file AUTOLOG and
then report the problem to the Response Center for assistance.
212 Message Could not set FILE equation for NL.PUB.SYS=NL (INSTERR #212)
Cause An attempt to set a file equation for NL.PUB.SYS through the
hpcicommand intrinsic failed. FILE Command Table is possibly full.
Action • Check if any further FILE commands can be entered with the FILE
command.
• RESET any user file equations.
• Take appropriate corrective measures and run HPINSTAL again.
HPINSTAL will reissue any required file equations.
• Contact the Response Center if further assistance is required.
213 Message HPINSTAL failed to copy over filename from CD-ROM (INSTERR
#213)
Cause The installer attempted to copy filename from CD-ROM and was unable to
do so.
Action • See if filename already exists in the local group/account. If so purge it.
• See if there is a file equation in effect that affects the filename. If so,
RESET it.
• Try to copy filename from the CD-ROM using the COPY command.
•Re-try.
214 Message Internal error during SYSGEN process (INSTERR #214)
escapecode
= number
Cause An unforeseen error occurred during the SYSGEN process creating the
CSLT.
Action Document all messages prior to the error. Save AUTOLOG and then con
tact the Response Center for assistance.
215 Message Unable to MOUNT/DISMOUNT LDEV ldev (INSTERR #215)
avr_ldev status: info = number, subsys = number
Cause An unexpected error was returned while attempting to mount or dismount
a CD-ROM volume mounted in a SCSI CD-ROM drive.
Action • Document all messages prior to the error. Save AUTOLOG and then
contact the Response Center for assistance.
216 Message Cannot execute from groupname.SYS group. (INSTERR #216)
Cause The installer was run from an invalid group with the ISS option.