HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
365
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
191 Message Error encountered while setting SYSGLOG file equation.
(INSTERR #191)
Cause The installer attempted to issue the file equation:
:FILE SYSGLOG;ACC=APPEND;MULTI
Action • Document any error message text prior to the error.
• FILE Command Table is possibly full.
•Do a LISTEQ command to determine which USER file equations can be
RESET.
• RESET any USER file equations.
• Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• Contact the Response Center if further assistance is required.
192 Message Error encountered while purging the file SYSPROGF. (INSTERR
#192)
Cause The installer was attempting to purge the file SYSPROGF.
Action • Document any error message text prior to the error.
• Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
193 Message Error encountered while redirecting input to SYSPROGF.
(INSTERR #193)
Cause The installer attempted to issue the command:
:LISTF MISCP.@.SYS,6; SYSPROGF
Action • Document any error message text prior to the error.
• Purge the file SYSPROGF.
• Reset the file equation SYSPROGF.
• Run the installer again.
• Contact the Response Center if further assistance is required
Message 194-196 Not used
197 Message Error setting IODFDATA.PUB.SYS file equation. (INSTERR #197)