HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
364
187 Message The installer encountered a corrupt variable: MPE_TARG_VUF.
(INSTERR #187)
Cause The data retrieved from the variable MPE_TARG_VUF is corrupt.
Action • Document any error message text prior to the error.
• Use SHOWVAR MPE_TARG_VUF to check the status of the variable.
• Print the INITCIVR.INSTALL. There should be a line with a SETVAR
command for the indicated variable. If the line does exist, execute
INITCIVR and run HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not contain the
SETVAR command for the listed CI variable, VSCLOSE both CD-ROM
volumes and follow the setup procedures in the HPINSTAL manual.
Run HPINSTAL from the start.
188 Message Encountered an error building the file TARGVUF. (INSTERR
#188)
Cause The installer was attempting to build the file TARGVUF.
Action • Document any error message text prior to the error.
• If old TARGVUF exists, purge it.
• Check for enough free disk space to build files. There are two methods
for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
189 Message Error encountered purging the file SYSGLOG. (INSTERR #189)
Cause The installer was attempting to purge the log file SYSGLOG.
Action • Document any error message text prior to the error.
• Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
190 Message The installer encountered an error building the file SYSGLOG.
(INSTERR #190)
Cause The installer was attempting to build the file SYSGLOG.
Action • Document any error message text prior to the error.
• If old SYSGLOG exists, purge it.
• Check for enough free disk space to build files. There are two methods
for obtaining additional disk space: