HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
358
Action • Check the accompanying error message and the escape code displayed
for CREATEPROCESS.
• Take corrective action and run the installer again.
• Contact the Response Center if further assistance is required.
159 Message File command error occurred for filename file. (INSTERR #159)
Cause Setting a file equation required by Patch selector failed.
Action •FILE Command Table is possibly full.
• Check if any further file commands can be entered with the file
command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
160 Message HPCIPUTVAR failed in create_AUXHDR. (INSTERR #160)
Cause The installer issued the HPCIPUTVAR intrinsic, and it failed. The status
returned for the intrinsic is displayed before this message.
Action • Check the error message from the HPCIPUTVAR intrinsic and based
on the status value displayed, take corrective action.
• Run the installer again.
• Contact the Response Center for further assistance.
161 Message HPCIGETVAR failed in create_AUXHDR. (INSTERR #161)
Cause The installer issued the HPCIGETVAR intrinsic and it failed. The status
returned for the intrinsic is displayed before this message.
Action • Check the error message from the HPCIGETVAR intrinsic and based
on the status value displayed, take corrective action.
• Run the installer again.
• Contact the Response Center if further assistance is required.
162 Message HPCIDELETEVAR failed in create_AUXHDR. (INSTERR #162)
Cause The installer issued the HPCIDELETEVAR intrinsic and it failed. The
status returned for the intrinsic is displayed before this message.
Action • Check the error message from the HPCIDELETEVAR intrinsic and
based on the status value displayed, take corrective action.
• Run the installer again.
• Contact the Response Center if further assistance is required.
163 Message OSSOM replacement patch VUF is < or = the current
OS id (INSTERR #163)
Cause There is an OSSOM replacement patch on the PowerPatch tape, which has
a vuuff that is older than the OSSOM on the system being patched.
Action This PowerPatch tape should not be used with your level of system.
Contact the Response Center for a newer PowerPatch tape.