HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
356
Cause The COMMAND intrinsic returned a nonzero command error when the
installer attempted to stream an IFILE.
Action • Ensure there are no STREAM UDCs.
• Check the STREAMS and SPOOLER functionality by streaming the
indicated IFILE manually.
• Check the indicated IFILE for a valid JOB card.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
148 Message Filename FREADLABEL failed. (INSTERR #148)
Cause Patch Selector failed while trying to read the user label on the file.
Action For AUTOINST:
• The file filename may be corrupted. Restore it from the PowerPatch
tape.
• Run AUTOINST again. If unsuccessful a second time, contact the
Response Center for assistance.
For HPINSTAL:
• Restart HPINSTAL. It will restore files from the PowerPatch tape
again. If the error occurs again, contact the Response Center for
further assistance.
149 Message Patch Selector internal error. (INSTERR #149)
Cause Patch Selector encountered an internal error which is displayed prior to
this message.
Action Note all displayed error messages. Save the files, PATCHAUD and
INSTERRS. Contact the Response Center for assistance.
150 Message Patch Selector encountered non-installer error. (INSTERR
#150)
Cause Patch Selector encountered a non-installer error which is displayed prior
to this message.
Action Note all displayed error messages. Save the files PATCHAUD and
INSTERRS. Contact the Response Center for assistance.
151 Message The installer was unable to write to the last record
of AXLDEV1.PUB.SYS (INSTERR #151)
Cause The installer tried to write to the last record of AXLDEV1 and failed.
Action
152 Message Error resetting CSLT file equations. (INSTERR #152)
Cause The file RESETFEQ, containing RESET statements, was not successfully
executed.
Action • Examine the RESETFEQ file to see if the RESET statements are in
the correct format.
• Then execute RESETFEQ by hand, and restart the installer.