HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
353
Cause CUSTOM failed either accessing a record from SLTFEQ, reading
SLTFEQ, or updating SLTFEQ.
Action • Document any error message text prior to the error.
• Purge SLTFEQ if it exists.
• Run HPINSTAL again from the beginning.
• Contact the Response Center if further assistance is required.
133 Message The SLTFEQ file does not contain the name record. (INSTERR
#133)
Cause CUSTOM failed when attempting to replace a SYSPROG file name in the
SLTFEQ file with an OPT DRIVER file name.
Action • Document any error message text prior to the error.
• Do a LISTF,3 on @INFO.INSTALL.SYS and FSLTFEQ.INSTALL.SYS.
All of the files should have been created about the same time. If they
were not, follow the instructions in the installation guide to perform
initialization by using the SETUP process.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
134 Message Installation requires 787,000 sectors of disk space
on the System Volume set to stage the files for building a
customized
SLT. You do not have that space available. Please consult the
Error
messages section for alternatives to resolve this problem.
(INSTERR #134)
Cause The installer verifies it has enough disk space for the creating the CSLT
by building a 787,000 sector file. If the build fails, the installer prints this
message and terminates.
Action • Ensure that there are 787,000 sectors of disk space for running the
installer. There are two methods for obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the permanent and
transient space allocation assignments to 100% on all system volumes
except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
— Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
# Message The file filename from the POWERPATCH tape was not
successfully
processed. To continue with the installation, consult the
customer installation
procedures. (INSTER #135)
Cause The installer failed to decrypt a file from the POWERPATCH tape.
Action • Check for tape errors, clean tape heads, etc.