HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
347
• If the file INDIRECT.USL.SYS exists, purge it, and run the installer
again.
• Determine the current job from the HPINSTFL file and check the
JOB's existence and/or termination.
• If the ifilename identified by HPINSTFL exists, inspect that file for
valid job commands. If this inspection shows that the file is not a valid
job, either purge the file, or remove it from the USL.SYS group.
• If the ifilename identified by HPINSTFL exists and inspection of the
file shows that the file is a valid job, the file may be corrupted. Purge
the file, and restore it again from the SUBSYS tape.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
99 Message Corrupt filename file. (INSTERR #99)
Cause Format of filename is unusable by the installer. Each line should be a
proper file equation format.
Action • If the filename is SLTFEQ, purge SLTFEQ and HPINSTFL files.
• Restart the installer.
100 Message The patched program and data files were not successfully
stored.
To continue with the installation, refer to the installation
manual. (INSTERR #100)
Cause The JCW STOREJCW contained an error value after execution of
AUTOPSTR.INSTALL.SYS to store the patch program and data files.
AUTOPSTR is run with the INFO string:
:STORE !TMPSTR02; STORTAPE;SHOW=OFFLINE;PROGRESS
Action • Ensure that a device with class LP is included in your configuration.
• Check file equates, STORE command, etc.
• Reset STOREJCW to OK.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
101 Message The installer failed setting the file equation for
INTLOG. (INSTERR #101)
Cause Setting the INTLOG file equation required by the installer for the file
INTLOG failed.
Action •FILE Command Table is possibly full. Do a LISTEQ command to
determine which USER file equations can be RESET. RESET any
USER file equations.
• Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• Contact the Response Center if further assistance is required.
102 Message The installer failed to purge AUTOLOG.INSTALL. (INSTERR #102)