HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
346
Cause An internal installer variable is corrupt. This error represents a serious
problem with an internal variable passed to the module that updates the
staged system libraries.
Action • If this error is produced, please document all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and the file
INTLOG.INSTALL.SYS, and then report the problem to the Response
Center for assistance.
95 Message The installer encountered errors adding SOMs to NM Libraries.
(INSTERR #95)
Cause The installer called the link editor to add or copy a SOM to either the NL
or the XL and the command failed.
Action • Record the error messages preceding this message.
• Print file AUTOLOG.INSTALL.SYS to view detailed error from link
editor.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
96 Message 96 Not used
97 Message An error was encountered purging SOMs in the NM Library.
(INSTERR #97)
Cause The installer called the link editor with a PURGEXL;ENTRY= xxx,
command, (where xxx is a SOM name), and the command failed.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from link
editor.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
98 Message The installer encountered an error while monitoring
a streamed job. Error status returned by JobInfo intrinsic:
status
. (INSTERR #98)
Cause A call to the JOBINFO intrinsic failed while the installer was attempting
to obtain the number of a given job name or to obtain the state of a job.
The job in question should be the last job streamed.
Action • If the USL, UXL, UNL groups were not purged prior to starting the
installation, purge them and restart the installation procedures.
• Check the last streamed job's spoolfile, if it exists. The jobs streamed
by the installer are listed in the HPINSTFL.INSTALL.SYS file.
• Ensure the spooler has been started for the LP device.
• Type LISTF I???????.USL.SYS.