HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
344
Action • If file NL.INSTALL.SYS exists, purge it.
• Take appropriate corrective measures and run the installer again.
• If error persists, copy error messages from screen and please contact
the Response Center for assistance.
88 Message Error issuing file equations for the Customized System
Load Tape. (INSTERR #88)
Cause Issuing the file equations in SLTFEQ failed.
The installer issues file equations to equate new or patched system
programs/opt drivers. SLTFEQ is a file of FILE commands that is executed
by the installer to set the file equations prior to calling SYSGEN to create
the CSLT.
Action •FILE Command Table is possibly full. Do a LISTEQ command to
determine which USER file equations can be RESET. RESET any
USER file equations.
Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• HPPATH variable is a non-standard path. Issue the following
command:
:SETVAR HPPATH “!HPPATH,PUB,PUB.SYS,ARPA.SYS”
Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• Contact the Response Center if further assistance is required.
89 Message Error while issuing file equation for the NL library. (INSTERR
#89)
Cause The installer attempted to issue the file equation:
:FILE NL.PUB.SYS=NL
(NL being in the local group INSTALL.SYS), prior to calling SYSGEN to
create the CSLT.
Action •FILE Command Table is possibly full. Do a LISTEQ command to
determine which USER file equations can be RESET. RESET any
USER file equations.
• Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• Contact the Response Center if further assistance is required.
90 Message Error while issuing file equation for the XL library. (INSTERR
#90)
Cause The installer attempted to issue the file equation:
:FILE XL.PUB.SYS=XL
(XL being in the local group INSTALL.SYS), prior to calling SYSGEN to
create the CSLT.