HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
343
• Check for enough free disk space to build files. There are two methods
for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
84 Message BUILDXL of the RELINKER patch file NLLINK.INSTALL.SYS
failed. (INSTERR #84)
Cause The installer called the link editor to perform a BUILDXL of
NLLINK.INSTALL, a temporary work nl, in preparation for relinking
procedures in the OS SOM.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from link
editor.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
85 Message The installer encountered LINKEDITOR errors executing
the RELINKER PROCEDURE. (INSTERR #85)
Cause RELINKING of Procedures by the link editor failed.
Action • This error represents a problem with an internal link editor error
while relinking procedures in the OS SOM.
• If this error is produced, please document all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and the file
INTLOG.INSTALL.SYS, and then report the problem to the Response
Center for assistance.
86 Message Purge of NL.INSTALL.SYS failed when applying RELINKER
patch. (INSTERR #86)
Cause The installer was attempting to purge the NL in preparation of rebuilding
it while relinking procedures in the OS SOM.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
87 Message Rename of NLLINK.INSTALL.SYS to NL.INSTALL.SYS failed
when applying a RELINKER patch. (INSTERR #87)
Cause The RENAME of the work nl, NLLINK.INSTALL.SYS, to
NL.INSTALL.SYS failed while relinking procedures in the OS SOM.