HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
338
Action If this error is produced, please document the all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
64 Message Resetting file equation SPLINTR failed. (INSTERR #64)
Cause Resetting the file equation SPLINTR failed while patching CM intrinsics.
Action If this error is produced, please document the all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
65 Message Resetting file equation INTDECL failed. (INSTERR #65)
Cause Resetting the file equation INTDECL failed while patching CM intrinsics.
Action If this error is produced, please document the all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
66 Message Purge of SYSINTR.INSTALL.SYS failed. (INSTERR #66)
Cause The installer attempted to purge an old SYSINTR file before beginning to
patch NM intrinsics.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
67 Message Purge of SPLINTR.INSTALL.SYS failed. (INSTERR #67)
Cause The installer attempted to purge an old SPLINTR.INSTALL file before
beginning to patch CM intrinsics.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
68 Message Copy of SYSINTR.PUB.SYS to SYSINTR.INSTALL.SYS failed.
(INSTERR #68)
Cause The installer was attempting to copy SYSINTR.PUB.SYS to
SYSINTR.INSTALL.SYS.
Action • Examine file SYSINTR.INSTALL.SYS for accessors other than the
installer.
• If SYSINTR.INSTALL.SYS is being accessed, free up
SYSINTR.INSTALL.SYS.
• Check for free disk space to copy file, and if needed free up disk space.
There are two methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.