HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
337
59 Message Setting file equation SPLINTR failed. (INSTERR #59)
Cause Setting the SPLINTR file equation required by the CM intrinsic
builder/patcher BUILDINT failed.
Action •FILE Command Table is possibly full.
• Check if any further file commands can be entered with the FILE
command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• Contact the Response Center if further assistance is required.
60 Message Setting file equation INTDECL failed. (INSTERR #60)
Cause Setting the INTDECL file equation required by the CM intrinsic
builder/patcher BUILDINT failed.
Action •FILE Command Table is possibly full.
• Check if any further file commands can be entered with the FILE
command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the installer again. The
installer will reissue any needed file equations.
• Contact the Response Center if further assistance is required.
61 Message Error occurred while patching System INTRINSICS file.
(INSTERR #61)
Cause The installer checks the results of the calls to the CM intrinsic
builder/patcher BUILDINT.PUB.SYS and the NM intrinsic patcher
ABLDINTX.INSTALL.SYS by checking the status of the system JCW. A
nonzero value (error) value was returned.
Action • Print the file AUTOLOG.INSTALL.SYS to check for possible detailed
error from either BUILDINT or ABLDINTX.
• Take appropriate corrective measures and run the installer again.
If the error cannot be corrected, please document all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
62 Message Resetting file equation SYSINTR failed. (INSTERR #62)
Cause Resetting the file equation SYSINTR failed while patching NM intrinsics.
Action If this error is produced, please document the all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
63 Message Resetting file equation SYSINTRN failed. (INSTERR #63)
Cause Resetting the file equation SYSINTRN failed while patching NM
intrinsics.