HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
335
• Contact the Response Center if further assistance is required.
51 Message Error trying to RUN AUTOCM.INSTALL.SYS. (INSTERR #51)
Cause Could not create AUTOCM process. Createprocess error: status
• The CREATEPROCESS intrinsic returned an error status when
attempting to execute autocm_filename.
• Check the returned CREATEPROCESS error in the MPE/iX
Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for further errors.
• Ensure INSTALL group has sufficient capabilities. (need CAP=PH).
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
52 Message An error occurred while modifying SL. (INSTERR #52)
Cause AUTOCM.INSTALL.SYS encountered an error in modifying the SL.
AUTOCM calls the SEGMENTER programmatically to first delete
segments in the staged system SL and then adds new subsys or patched
segments to the staged system SL.
Action • Print the file AUTOLOG.INSTALL.SYS to ascertain specific error.
• Check for additional errors in file SLOUTPUT.OUT.HPSPOOL.
• Take appropriate corrective measures and run the installer again.
• If you are patching an MPE/iX system release 4.0 or later, ensure that
the version of AUTOINST you are running is D.00.05 or later. If the
AUTOINST version is earlier than D.00.05, restore A@.F@ from the
PowerPatch tape, and run AUTOINST again.
• Contact the Response Center if further assistance is required.
53 Message Patching INTRINSIC without correct component type. (INSTERR
#53)
Cause The installer encountered an error in processing the file TMPSTR00.
TMPSTR00 contains entries for both Compatibility Mode (CM) and Native
Mode (NM) intrinsic files to be patched. The installer encountered an
entry that was not a CM or NM intrinsic file.
Action • If this error is produced, please document all messages prior to the
error.
• Save the file AUTOLOG.INSTALL.SYS, and the file
TMPSTR00.INSTALL.SYS. Report the problem to the Response
Center for assistance.
54 Message 54 Not used
55 Message Setting file equation SYSINTR failed. (INSTERR #55)
Cause Setting the SYSINTR file equation required by the NM intrinsic patcher
ABLDINTX.INSTALL.SYS failed.
Action •FILE Command Table is possibly full.