HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
334
Cause An error occurred while SYSGEN was producing the Customized System
Load Tape (CSLT).
The installer invoked SYSGEN to build the CSLT. SYSGEN encountered
an error and the installer trapped on the error condition.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from
SYSGEN.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
47 Message Error executing SAINT commands while building START IMAGE.
(INSTERR #47)
Cause SAINT encountered an error in building new START image. The installer
invoked SAINT to build the new START image. SAINT encountered an
error and the installer trapped on the error condition.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from
SAINT.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
48 Message The installer failed to modify the system jcw JCW. (INSTERR
#48).
Cause A command issued by the installer to SETVAR JCW to a legal jcw value
failed.
Action • If this error is produced, please document all messages prior to the
error. Save the file AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
49 Message Error trying to RUN OCT.PUB.SYS. (INSTERR #49)
Cause Could not create OCT process. Createprocess error: status
Action • The CREATEPROCESS intrinsic returned an error status when
attempting to execute oct_filename.
• Check the returned CREATEPROCESS error in the MPE/iX
Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for further errors.
• Ensure group for OCT has sufficient capabilities. (need CAP=PH).
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
50 Message An error occurred in translating the SL. (INSTERR #50).
Cause OCT encountered an error in translating the SL.
The installer invoked OCT to translate newly installed segments in the
staged system SL. OCT encountered an error and the installer trapped on
the error condition.
Action • Print the file AUTOLOG.INSTALL.SYS to check OCT error.
• Take appropriate corrective measures and run the installer again.