HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
332
• Save the PATCHAUD and INSTERRS files.
• Contact the Response Center.
39 Message Error while getting records from AUTOGEN. (INSTERR #39)
Cause This error may occur if the AUTOGEN file is corrupted.
Action •For AUTOINST:
• Restore AUTOGEN@ from the correct PowerPatch tape.
• Run the installer again.
• Contact the Response Center if further assistance is required.
• For HPINSTAL: Restart HPINSTAL. It will restore the files again. If
the error occurs again, contact the Response Center for further
assistance.
40 Message The installer failed to checksum SL. (INSTERR #40)
Cause The Patch Selector is trying to checksum the segments in the local copy of
the SL, and has failed to do so.
Action • Enter LISTF SL.INSTALL.SYS to verify the copy of the SL exists.
• Verify that the SEGMENTER can access the SL outside of the
installer:
:SEGMENTER
-SL SL.INSTALL.SYS
-LISTSL
Press [[CTRL]] [[Y]] to stop listing all the SL segments.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
41 Message AUTOGEN, AUTODEP VUF MISMATCH (INSTERR #41)
Cause AUTOGEN and AUTODEP from the PowerPatch tape should have the
same file VUF. This error can only be caused if two different PowerPatch
tapes are in use.
Action For AUTOINST:
• Restore A@,F@ from the correct PowerPatch.
• Take appropriate corrective measures and run the installer to start
installation again.
• Contact the Response Center if further assistance is required.
For HPINSTAL:
• Restart HPINSTAL; it will restore the files from the PowerPatch tape
again. If the error occurs again, contact the Response Center for
assistance.
42 Message The installer failed to modify the JCW CIERROR. (INSTERR #42)
Cause The installer could not modify the JCW CIERROR to within a legal range.